The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Dave McCracken Memorial Shotgun Forum

Reply
 
Thread Tools
Old April 26, 2013, 05:49 PM   #1
BrownTrout
Member
 
Join Date: December 5, 2009
Location: Iowa
Posts: 31
Ithaca SxS help

Hi, I'm needing a little help regarding an older SxS that I just purchased.

It is an Ithaca 12 ga double. Serial # is in the 150xxx range, which I believe makes it a "Minier" model, made 1907.

It is in pretty rough shape, missing the forend. It has a buttstock, but obviously from a different gun.

A few questions:
1. The ad stated the gun has 2 3/4" chambers. Is this true?
2. Does this have any value whatsoever? I paid $73 for it, and was planning to use it as a project, but I don't want to ruin a valuable gun.
3. Does anyone know of different stocks that may fit the "Minier" model? For instance, will a Flues buttstock fit?
BrownTrout is online now  
Old April 26, 2013, 07:53 PM   #2
BigD_in_FL
Junior member
 
Join Date: December 20, 2012
Location: The "Gunshine State"
Posts: 1,981
It MAY have 2-3/4, but a smith with a chamber gauge can tell you in 5 seconds. It could also be 2-1/2 or 2-9/16. In any event, being that old and in poor shape, a trip to a QUALIFIED smith to check for soundness is in order before firing.

You could try Gun parts (aka Numrich) for parts or www.doublegunshop.com - lots of good folks who know double guns and may have some leads for parts

Also look here: http://www.shotgunworld.com/bbs/view...d329b731c03a26
BigD_in_FL is offline  
Old April 26, 2013, 08:57 PM   #3
PetahW
Senior Member
 
Join Date: September 19, 2008
Posts: 4,679
FWIW, even if it were in mint condition, it should not be shot with ANY modern shotshells, period - even so called "low brass", "field" or "Target" loads.

The reason is that in 1926, all the ammo companies upgraded their shotshell loadings - causing even Ithaca to discontinue the Flues Model & introduce the much stronger NID Model.

It should not be shot at all, until a qualified double gunsmith checks it out as OK (not some AR parts-changer).


Whether it's for a project or "as-is", if it checks out as okey to shoot - proper, low-pressure ammo for these old guns is readily available from the likes of RST, PolyWad, Kent Cartridge, & GameBore.


.
PetahW is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:06 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06986 seconds with 9 queries