The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old April 9, 2013, 06:49 PM   #1
reynolds357
Senior Member
 
Join Date: December 10, 2012
Posts: 2,543
Problem reloading once fired brass/Ruger American

I have 6 boxes for frontier .243 factory loaded ammunition. As best I can tell from the lot number, it was mfg. in 1973. I shot one box just for the brass. Shooting it in my Ruger American. I did not really examine the brass when firing because I was just breaking the rifle in and making reloadable brass. When I tried to re-prime the brass, the primers had absolutely no tension in the primer pocket. None whatsoever on any of the 20 pieces of brass. I was using WLR primers that I have loaded from that lot before, so I know there is no primer issue. I verified it with a Federal which had the slightest bit of pressure, but no where near what it should be. I went back to my press and looked at some of the primers that came out of the brass. They were flat. They were some of the flattest primers I have ever seen. I must admit that early 70's ammo is slightly older than I am, so I am no expert on it. Was ammo loaded at these high pressures in the early 70's? Has age increased the pressure of the ammo due to powder decomposition? Has anyone who has an American noticed abnormal pressure signs in brass fired from it?
My thoughts at the moment are to pull down the other 5 boxes, but trying to avoid that. Any thoughts?
reynolds357 is offline  
Old April 9, 2013, 06:57 PM   #2
steve4102
Senior Member
 
Join Date: December 23, 2005
Location: Minnesota
Posts: 2,321
Do the Google on Frontier brass. Not a whole of of respect for it, soft and chitty. I would shoot the remaining loads and toss the brass in the scrap bucket.
steve4102 is online now  
Old April 9, 2013, 07:39 PM   #3
BigD_in_FL
Junior member
 
Join Date: December 20, 2012
Location: The "Gunshine State"
Posts: 1,981
Frontier was the price point Hornady ammo back then
BigD_in_FL is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:38 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05798 seconds with 7 queries