The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old April 5, 2013, 08:55 AM   #1
t45
Senior Member
 
Join Date: January 29, 2010
Location: Belews Creek, NC.
Posts: 604
Savage O&U 24v headspace

Guys my Savage 24v has a wore out or loose hinge pin that is allowing increased headspace. I have a slight side to side movement after lock up. My new 30-30 brass is showing the dreaded ring at the bottom of the case body at the head. Can a gunsmith replace the pin to a larger dia and tighten up the lock-up?
t45 is offline  
Old April 5, 2013, 09:28 PM   #2
PetahW
Senior Member
 
Join Date: September 19, 2008
Posts: 4,679
I'd suggest you contact Savage Customer Service, before entrusting it to anyone but a qualified doublegun 'smith.


.
PetahW is offline  
Old April 5, 2013, 10:05 PM   #3
4V50 Gary
Staff
 
Join Date: November 2, 1998
Location: Colorado
Posts: 16,940
Or send it to Trinidad State Gunsmithing School. They'll give it to a student to fix (that's how we get our points in repair class). We get more points if we have to make replacement parts (rather than slap in and adjust factory replacements). The students do the work under the eye of a very experienced gunsmith (dang, he even knew how they attached deck plates onto battleships).
__________________
Vigilantibus et non dormientibus jura subveniunt. Molon Labe!
4V50 Gary is online now  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:19 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05593 seconds with 7 queries