The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old April 4, 2013, 03:45 PM   #1
Dragline45
Senior Member
 
Join Date: November 30, 2010
Posts: 2,405
Bead Blasting Media

I am finally getting around to bead blasting my stainless Sig 232, but before I start I want to ask a couple questions.

What media do you all prefer?

I was thinking either 80 grit glass bead media, or the finer 100/170 grit. I know the 100/170 grit media will give more of a satin shine finish and the 80 grit will give a duller satin finish. But since this is a carry gun, will the 80 grit be that much less prone to surface scratches compared to the 100/170? If the difference is negligible I will probably go with the finer 100/170.

Also around what PSI do you guys blast at? I will experiment on scrap steel to find what gives me the look I want, but would like a starting point. I found people online saying to stick with 40, and others going all the way up to 85.
Dragline45 is offline  
Old April 4, 2013, 04:39 PM   #2
velocette
Senior Member
 
Join Date: May 25, 2007
Location: South Florida
Posts: 834
glass bead blasting

Glass bead blasting is a nice way to gain a smooth satin finish, removing little or no base metal. The glass beads actually peen the surface with may tiny little depressions shaped like the beads themselves.
Blasting pressure is kept low (20 ~ 50 psi) to avoid fracturing the little glass beads. Fractured beads from higher pressures result in sharp edged beads which will cut or remove material from the substrate.
If you are doing the bead blasting yourself, be certain to buy high quality beads that have NOT been used previously (no fractured beads) be certain that your blast nozzle is new or at least in very good condition and of the proper size for your compressors & regulators output, wear good eye protection and a dust mask. (even when using a booth) and start with your blast pressures fairly low.

Roger
__________________
Trigger control + Breath control + Sight alignment = Gun Control.
http://www.hrpclub.info/
NRA Smallbore Prone Master
velocette is offline  
Old April 10, 2013, 07:52 PM   #3
WallaceB
Member
 
Join Date: June 24, 2011
Posts: 25
How large of a compressor do you need to get good results?
WallaceB is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:23 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06028 seconds with 7 queries