The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old March 22, 2013, 12:23 PM   #1
TerminiTubes
Junior Member
 
Join Date: March 21, 2013
Posts: 3
Overtightened trigger screw, bolt scratch

Hi,
So this is my first post and of corse it is a plea for help. My girlfriend and I just got into bolt action and I was installing a HS precision removable bottom magazine on our Remington 700, and like an idiot I over tightened the the screw that attaches the bottom metal and stock to the barrel, thus pinning the bolt in place. I since shortened the screw and there is a tiny bit of damage to the bolt, has this destroyed the bolt or will it continue to function normally?

Thanks for the help
Karl

Last edited by TerminiTubes; March 22, 2013 at 12:33 PM.
TerminiTubes is offline  
Old March 22, 2013, 12:38 PM   #2
Scorch
Senior Member
 
Join Date: February 13, 2006
Location: Washington state
Posts: 11,428
You should be fine.
__________________
Never try to educate someone who resists knowledge at all costs.
But what do I know?
Summit Arms Services
Taylor Machine
Scorch is offline  
Old March 22, 2013, 12:41 PM   #3
TerminiTubes
Junior Member
 
Join Date: March 21, 2013
Posts: 3
Thanks a bunch, the instructions did not include that as a possible mistake to make. I looked at ever video I could find on the web before taking out the dremel and praying to the gods. All in all it was easy for a person with 0 gun smithing skills to pull off. Aside from the not realizing a bolt resize was in order.
TerminiTubes is offline  
Old March 22, 2013, 04:38 PM   #4
oldgunsmith
Senior Member
 
Join Date: January 9, 2013
Posts: 278
Not likely you hurt anything to worry about.
oldgunsmith is offline  
Old March 22, 2013, 05:55 PM   #5
TerminiTubes
Junior Member
 
Join Date: March 21, 2013
Posts: 3
I did how ever open the bolt while it was pressed in place by the screw, there is no apparent gouges or so on the bolt, small marks but nothing that looks like it compromised the bolt. I would assume the metal for the bolt is much harder then the metal used in manufacturing the screw? Any ways I just wanted to make sure I would not cause a catastrophic failure when firing the first round out of it.
TerminiTubes is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:50 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06128 seconds with 7 queries