The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old March 12, 2013, 05:31 PM   #1
nigsbro
Junior Member
 
Join Date: March 12, 2013
Posts: 2
any of you guys use a mec automate?

I know its alot to ask but over here in the uk there isnt anyone I can ask. could someone take some messurements for me in iches or mm off their auto-mate please? as been looking around now for weeks with no luck,
the messurements I need are below.
depth
slope size,
front hight up to slope
rear hight
disk size aross disk
center of the disk to the conecting arm bolt
lenght of drop arm from disk bolt to upper bolt thats on the rear of the press
and thickness of steel used for the auto mate and the disk.

If someone could do this for me it would be a great help as im trying to make a 12volt unit up.
nigsbro is offline  
Old March 15, 2013, 03:35 PM   #2
kdemers58
Member
 
Join Date: February 9, 2013
Posts: 27
i thought i new all the mec but i am not good with the automate i have 5 mec's 2 single stages and 3 progessive's 600 and 650 jr if i can help let me know
kdemers58 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:30 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07967 seconds with 9 queries