The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old March 14, 2013, 10:09 PM   #1
BigTex308
Senior Member
 
Join Date: October 26, 2012
Location: Texas
Posts: 259
Shotshell Loaders......Progressive or single stage

I'm wondering if I should get a single stage or progressive press.

I'm going to reload skeet loads and also steel for duck hunting. I won't reload a ton but I'd like to be able to crank out quite a bit of rounds in a short amount of time.

I know with brass reloading there is a HUGE difference between single stage and progressive. Is this the same with shotshell?


About how long does it take to make a box of shells once you have it setup on a single stage? Progressive?


Just trying to figure out if it's worth it to go progressive or if I'd be better off sticking with a single stage.


Also, what presses do you reccomend? I'm guessing one out of the MEC line up




Thanks in advance!



Ike
BigTex308 is offline  
Old March 15, 2013, 07:20 AM   #2
twice barrel
Member
 
Join Date: November 11, 2009
Posts: 98
Get a progressive for the target loads, set it up for that load, that hull and primer and leave it that way. Get a single-stage for your hunting loads.
twice barrel is offline  
Old March 15, 2013, 09:49 AM   #3
wild willy
Senior Member
 
Join Date: March 8, 2006
Posts: 217
I would get a Mec sizemaster to start with.Learn the basics easier to change from skeet to duck loads.If after you load on it a while you decide you want faster you can leave the sizemaster set up for your duck loads and get a progressive.Mec says 4 to 6 boxes a hour on the sizemaster its been a long time since I counted how many in a hour but if I remember correctly it was easy to get 6 boxes a hour

Last edited by wild willy; March 15, 2013 at 09:56 AM.
wild willy is offline  
Old March 15, 2013, 11:19 AM   #4
kdemers58
Member
 
Join Date: February 9, 2013
Posts: 27
i have 6 shot gun loaders a 5 are mec and 1 is a ponce/warren i like the mec much simpler to change 3 are 650 the others are 600 one of the 650 is set up just for loading steel duck loads i took a alder 12 ga 650 and sent it into mec they rebuilt it and made it a steel only loader works great you can load around 10 boxes a hour once its all set up the single stage are set for 28 ga and 410 you get around 4-5 boxes a hour with them they make a grabber that will do it all but they are twice the price some of my friends at the club use them and they work great but they shoot 1000's of rounds a year . good luck
kdemers58 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:36 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05885 seconds with 7 queries