The Firing Line Forums

Go Back   The Firing Line Forums > Hogan's Alley > Handguns: The Revolver Forum

Reply
 
Thread Tools
Old March 15, 2013, 08:30 PM   #1
berettaprofessor
Senior Member
 
Join Date: November 23, 2008
Posts: 572
22LR/22WMR revolvers; accuracy?

For revolvers that are manufactured and sold with two cylinders, 22LR and 22WMR, how does that affect the accuracy of the 22LR component? I don't know how it works and would guess that the 22LR has a farther "jump" into the forcing cone...making them less accurate than a 22LR only revolver. Right or wrong?
berettaprofessor is offline  
Old March 15, 2013, 08:34 PM   #2
Bob Wright
Senior Member
 
Join Date: July 10, 2012
Location: Memphis, Tennessee
Posts: 1,708
I have had experience with only one such revolver, a Ruger Three Screw Super Single Six.

I used the magnum cylinder often, using the old .22 WRF cartridges for squirrel hunting. At times loaded up with .22 WMR for pests, crows etc.

I only occassionally used the L.R. cylinder, and not so much for fine target work as general plinking. If I lost any accuracy, it was not apparent to me.

Bob Wright
Bob Wright is offline  
Old March 15, 2013, 11:35 PM   #3
Newton24b
Junior member
 
Join Date: February 10, 2009
Posts: 974
accuracy is fine. each weapon will be slightly different based upon tolerances and ammunition used.

the only issues will be this, the 22 mag uses a larger bullet diameter the the 22lr,22l,22 short. as a result the barrel is sized for 22 mag projectiles. that means the standard 22 lrs have a big of extra bumping up to do. so accuracy will suffer slightly.

just like what happens when a black hawk convertible is used with the 9mm cylinder. a little freebore.
Newton24b is offline  
Old March 15, 2013, 11:38 PM   #4
Onward Allusion
Senior Member
 
Join Date: November 17, 2009
Location: IN
Posts: 1,647
Shooting off-hand, the difference between LR & Mag out of the same barrel is negligible.
__________________
"With great power, there must also come great responsibility." - Stan Lee

"All that is necessary for evil to triumph is for good men to do nothing." - Edmund Burke
Onward Allusion is offline  
Old March 16, 2013, 12:02 AM   #5
weblance
Senior Member
 
Join Date: October 3, 2012
Posts: 576
I can get 2" groups from my 5.5" Single Six, rested, at 25 yards, with the LR cylinder, and the ammo the gun likes. Good enough for anything I will ever need.
weblance is offline  
Old March 16, 2013, 07:50 AM   #6
rodfac
Senior Member
 
Join Date: January 22, 2005
Location: Kentucky
Posts: 1,508
Here's a pic of my wife's 40 yr. old Ruger Single Six Convertible. That piece of masking tape is 2" square, and the group was shot at 25 yds from a sitting, back rest position. Ammunition was cheap bulk Remington .22 lr HP...the Golden Bullet type. The gun's capable of 1.5" gps with .22 Magnum ammunition as well, tho we don't use it much due to the cost. Best Regards, Rod

__________________
Our Flag does not fly because the wind blows against it, it is moved instead, by the dying breath of our patriots in uniform. Our Freedom is not free, it's been paid for many times over.
USAF Forward Air Controller, 5th Spl Forces,
An Loc, lll Corps, RVN, 69-70, Vietnam Vet '69-'73
rodfac is offline  
Old March 16, 2013, 12:11 PM   #7
Rogervzv
Senior Member
 
Join Date: February 5, 2011
Location: Huntington Beach, CA
Posts: 632
Ruger claims, and I believe them, that they have experimented with various barrel dimensions, and having the Single Six barrel also accommodate the .22 WMR round did not affect accuracy at all as measured by tests.

At any rate our Single Six is dead-on accurate, limited only by the shooter.
__________________
The difference between a citizen and a civilian is that the citizen makes the safety of the body politic his personal responsibility. The civilian does not.
Rogervzv is offline  
Old March 16, 2013, 12:27 PM   #8
hammie
Senior Member
 
Join Date: March 18, 2009
Location: Glendale, AZ
Posts: 491
The shorter sight radius of my 4 5/8 single six probably has more impact on grouping than anything else. In any case, I've never been able to tell any difference in accuracy between the .22 LR and .22 WMR cylinders.

Mr Wright has a good suggestion about using .22 WRF as an everyday load. I've been wanting to try that, but good luck trying to find ANY rimfire ammunition right now.
hammie is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:18 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2013 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.09219 seconds with 9 queries