The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Black Powder and Cowboy Action Shooting

Reply
 
Thread Tools
Old February 24, 2013, 03:48 PM   #1
Doc Hoy
Senior Member
 
Join Date: October 24, 2008
Location: Chesapeake, VA
Posts: 4,598
Finally got into the shop to fix my Geroco .357

This is the revolver I bought in FL and had shipped to VA.

Second time I took it out to shoot it, the pivot pin in the hand broke.



I also noted that the cam was worn badly though you can't really tell from the following photo.




So I made a new pivot pin and installed it in the hand by center punching the pin in the hand.

I also drove the cam out of the hammer by about a 16th inch and reshaped the face of it.



The revolver cycles very well now.

I did not heat treat the part because I have only a little knowledge of heat treating and I did not want to do more harm than good.

I'll let y'all know how it holds up.
__________________
Doc

My reading of history convinces me that most bad government results from too much government. Thomas Jefferson

Last edited by Doc Hoy; February 25, 2013 at 03:48 AM.
Doc Hoy is offline  
Old February 25, 2013, 01:11 AM   #2
logeorge
Junior Member
 
Join Date: December 24, 2007
Location: Ardmore, AL
Posts: 13
Hammer Cam

The cam in my ASM .357 single action was getting worn. I turned one out of a piece of O-1 drill rod, heated it with a butane torch to a bright red-orange color, let it stay for 10-15 seconds to even out then quenched it in 30W motor oil and drew it in melted lead for an hour, then ground the cam shape on it and tapped it in. Just did it last week. I have no way to test the hardness, but if it doesn't hold up, I'll let you know. Works O. K. for now. Got the drill rod at Fastenal for about $5.00 for a 1/4 x36 inch rod. L. O. G.
logeorge is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:28 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05584 seconds with 9 queries