The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old February 23, 2013, 10:12 PM   #1
9miller
Member
 
Join Date: January 11, 2012
Posts: 82
50gr. zmax help

Hey guys, I've already loaded the 55 grain vmax bullets and had a pet load for it that shot a solid group at 25 yards with iron sights on my ar, 16" barrell and 1:9 twist. However, the vmax is unavailable for a while and i had to settle on the 50 grain zmax, to my understanding, the vmax and zmax are the same except the colored polymer tip being red and green. I was wondering if you guys had any pet loads with the 50gr. zmax using cci small rifle primers, and aa-2015. Already looked at 3 sources and they all have different load data. thanks in advance for any help.
In case you were wondering about the 55 grain load, it was the vmax,, 25 grains of h335, cci 400 and range brass set to a COL of 2.22 . Give her a shot
9miller is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:51 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06290 seconds with 9 queries