The Firing Line Forums

Go Back   The Firing Line Forums > Hogan's Alley > Handguns: The Revolver Forum

Reply
 
Thread Tools
Old February 23, 2013, 02:02 PM   #1
VanderLaan
Junior Member
 
Join Date: May 18, 2012
Location: Central Illinois
Posts: 5
S&W 581 Questions...

Found a pretty cherry 581 at the local gun shop. It is a no dash gun. Has a small dot of rust on the side of the barrel that can be cleaned off with oil, but leaves a tiny pit. Overall, gun is 90- 95+ %. Comes withthe original wood and Houge grips. Any idea what a fair price would be? Can you tell me anything else about this model? I confess that I might be smitten, but I know nothing about them. . I would appreciate any insight that you may have.
__________________
I get up every morning looking to change the world and have one hell of a good time. It usually makes planning my day quite the challenge.
VanderLaan is offline  
Old February 23, 2013, 06:35 PM   #2
FlyFish
Senior Member
 
Join Date: January 20, 2009
Location: Overlooking the Baker River Valley
Posts: 1,496
The 581 is essentially the fixed-sight version of the 586 - the corresponding guns in stainless would be the 681 and 686. These guns were built on the S&W "L" frame, which is a bit beefier than the K frame but uses the same size grips. There are those who object to the full lug barrel, but personally I like the look, which is reminiscent of the Colt Python. I think most would agree that they are among the finest .357 revolvers made. I have a couple of the 686s, and a few 586s, and they are all very accurate and fun to shoot.

The no dash and -1 guns in this series were subject to a recall to fix an issue with the firing pin and bushing that could [very rarely] result in the cylinder locking up due to the primer cup flowing back in to that area with certain hot loads. Guns that have been modified by the factory will have an "M" overstamped in the frame cutout near the model number. I believe S&W will still make this modification at no cost and will cover shipping both ways. If the gun in question is to be used for SD, than you will want to be sure the modification has been, or will be, done. For range work it probably doesn't really matter.

With the current craziness in gun and ammo pricing generally, it's difficult to judge what would be a fair price. Based on your description and the general run up in quality revolver prices, I think that something in the $550 to $600 range is reasonable, but it's a seller's market these days and I see desirable guns bringing prices that would have been unthinkable just last year. I think on balance the 586 and 686 adjustable sight models are more marketable, but there were also a lot more of them made, so for those who like a fixed-sight revolver the 581 and 681 are harder to find and scarcity always carries a premium.

If I came across a 581 in good condition I suspect I'd be smitten and well and would likely pay top dollar to take it home.
__________________
NRA Benefactor Life Member
NRA Certified Pistol Instructor
SASS #84900
Pemigewasset Valley Fish & Game Club
FlyFish is offline  
Old February 24, 2013, 12:12 AM   #3
Tom Servo
Staff
 
Join Date: September 27, 2008
Location: Foothills of the Appalachians
Posts: 10,398
That's actually a very good price in my neck of the woods. Fixed-sight Magnums are some of the most practical fighting pistols ever devised, and the heavier L-Frame should have been the ideal gun for law enforcement. Problem was, they were too busy switching over to automatics, and the civilian market preferred target-sight models.

As such, the 581's are somewhat scarce and tend to fetch higher prices.
__________________
Sometimes it’s nice not to destroy the world for a change.
--Randall Munroe
Tom Servo is offline  
Old May 19, 2013, 09:27 PM   #4
catman1
Junior Member
 
Join Date: September 8, 2009
Posts: 4
My S&W 581

It has a perfect triger pull, right there..



catman1 is offline  
Old May 20, 2013, 02:59 PM   #5
P5 Guy
Senior Member
 
Join Date: December 1, 2005
Location: Tampa Bay
Posts: 1,155
A couple of years ago I bought a 681 with S&W target grips for $400.
In Florida the full capacity pistols are running crazy prices but revolvers are sitting on the tables of gun shows or display cases of stores gathering dust.
P5 Guy is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:45 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.08436 seconds with 7 queries