The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old February 23, 2013, 04:33 AM   #1
oldandslow
Senior Member
 
Join Date: October 2, 2007
Posts: 557
Thumblers tumbler RPM-OEM vs. Vacuum belt

Greetings, 2/23/13

I've got several thousand cases through my Thumbler's high speed tumbler with SS pins over the past year and noticed a difference between the RPM's with the stock, clear drive belt and a tighter, round rubber vacuum belt (Eureka,RD style, series 600).

I mark the drum and then time the turns for a full minute. The stock belt gives 42 rpm (repeated twice). The tighter vacuum belt gives 52 RPM's (repeated twice). This is with the same drum with a measured weight of 15 pounds. This means there has got to be some slippage with the stock belt even though it looks fine. Has anyone else looked at the speed of their stock drive belts? This means that I'm getting 25% faster RPM's and hopefully faster cleaning with the vacuum belt.

best wishes- oldandslow
oldandslow is offline  
Old February 23, 2013, 06:44 AM   #2
FlyFish
Senior Member
 
Join Date: January 20, 2009
Location: Overlooking the Baker River Valley
Posts: 1,483
That's interesting. I went to a vibratory tumbler years ago and don't use my Thumbler's much any more, but when it was in regular use (before anyone even made the other kind), I would get bits of rubber dropping onto the frame under the belt. I never knew why and never had to replace the belt, but I'm guessing it was due to the slippage you describe.
__________________
NRA Benefactor Life Member
SASS #84900
03 FFL
Pemigewasset Valley Fish & Game Club
FlyFish is offline  
Old February 24, 2013, 03:39 PM   #3
paulo57509
Junior Member
 
Join Date: January 10, 2011
Posts: 8
There is definitely some slippage going on with the OEM belt, but I think that is by design. You don't want the belt so tight because it may start wearing on the motor bushings and the nylon tumbler shaft bushings.
paulo57509 is offline  
Old February 24, 2013, 06:02 PM   #4
lll Otto lll
Senior Member
 
Join Date: June 1, 2008
Location: Lone Star State
Posts: 167
Quote:
Has anyone else looked at the speed of their stock drive belts?
I just replaced my belt with a OEM. I get close to 60 rpm's. There shouldn't be any slippage between the belt and pulleys. Even oil from your fingers can make the belt slip. Try cleaning the belt in dishwashing liquid and degrease the pulleys with alcohol.

Using a vacuum cleaner belt could cause unexpected wear on the motor.
lll Otto lll is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:34 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06814 seconds with 7 queries