The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old February 22, 2013, 12:32 AM   #1
savagest
Member
 
Join Date: February 9, 2013
Posts: 96
Saving Brass. 308 vs 7.62x51

I am saving up my brass for when I get a reloading station. I have got some Federal gold medal in 308 and 7.62. I heard there is a primer difference between the two. I have looked at the both of them and they look the same. I don't want to have to buy two sets of primers to reload, am I going to run into an issue here or is there a solution here.
savagest is offline  
Old February 22, 2013, 01:08 AM   #2
NESHOOTER
Senior Member
 
Join Date: October 16, 2009
Posts: 509
Brass

It seems you have some commercial grade .308 and some mil spec 7.62 with a crimp on the primer which will need to be removed when time come to reloading. To answer your question no you will not have to have 2 different primers as the mil spec are known to have thicker primer cup (the face that the firingpin strikes) which are if used in semi-auto helps prevent slam fires or the like enjoy your new quest.
NESHOOTER is offline  
Old February 22, 2013, 09:10 AM   #3
5R milspec
Senior Member
 
Join Date: December 11, 2009
Location: South Carolina
Posts: 360
Show a pic of the two different cases,then we would be able to help out better.( primer up ) But if one of the two types of brass has a little extra ring around the primer,well then its crimped in primers.Not to worry though if this is the case,all you will need to do is to remove this by cutting it out with a chamfering tool,a few turns and its gone for good. No need to worry the primers are the same for either case,its just that one might be crimped in.
__________________
life is great but its better when you can own as many guns you wish to own.for me I haven't bought enough yet.
5R milspec is offline  
Old February 22, 2013, 09:41 AM   #4
rox
Member
 
Join Date: October 4, 2012
Posts: 56

Take a look inside the different cases. Do they all have a single central flash hole, or do some have 2 off-centre flash holes? Some military brass uses Berdan primers (2 flash holes), which needs special tooling to remove and different primers to the boxer primers usually used by reloaders. Photos and more details here.

..
rox is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:45 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06056 seconds with 7 queries