The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old February 21, 2013, 11:27 PM   #1
idek
Senior Member
 
Join Date: August 20, 2009
Posts: 579
typical weights of shotgun wads?

I'm playing around with a recoil calculator just for fun, but I don't know the weight of typical wads are for various gauges. Can anyone help me out with this? I'm wondering about these gauges and lengths:

.410 - 2.5" and 3"
20 gauge - 2.75" and 3"
12 gauge - 2.75" and 3"
idek is offline  
Old February 22, 2013, 11:37 AM   #2
rg1
Senior Member
 
Join Date: November 6, 2001
Posts: 744
Just for your curiosity I weighed a few samples:
20 ga.
Remington SP 20---24.2 grains average
Winchester WAA 20---30.1
Winchester WAA 20F1---25.1
12 ga.
Winchester WAA12R---29.5
Remington RXP12---38.8
Remington R12H----34.7
Remington SP12----32
Remington RP12----30.1
Don't load .410. The same wads are used in 2 3/4 and 3" shotshells. Unlike reloading for rifle-pistol, you use the exact primer, wad, powder, hulls, and charge listed in a published manual. You use the exact recommended components and do not switch one thing in the load listed. Don't think the weight of a wad will effect your ballistic charts much? Hope this helps.
rg1 is offline  
Old February 22, 2013, 11:38 AM   #3
Big Yac
Senior Member
 
Join Date: April 23, 2005
Location: Ohio
Posts: 422
honestly, you dont need the weight of the wad to calculate recoil. You need the weight of the gun in pounds, velocity of the load in fps, amount of shot (weight in grains), and the charge of powder in grains.
__________________
"...and that's the bottom line, because Big Yac said so."
Big Yac is offline  
Old February 22, 2013, 11:42 AM   #4
BigD_in_FL
Junior member
 
Join Date: December 20, 2012
Location: The "Gunshine State"
Posts: 1,981
Actually, it is the mass of the payload (ejecta) which does include the wad; however, it is very minute. I have always just plugged in 25 grains to get close enough

Lowest recoil comes from using the heaviest gun with the lightest and slowest load
BigD_in_FL is offline  
Old February 22, 2013, 01:23 PM   #5
idek
Senior Member
 
Join Date: August 20, 2009
Posts: 579
Thanks for the replies.

Yes, I figured that when the shot weighs a few hundred grains or better, that the exact weight of the wads probably didn't matter much. I was just looking for a good ballpark number I could put into the equation.
idek is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:13 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06117 seconds with 7 queries