|February 13, 2013, 11:45 PM||#1|
Join Date: August 30, 2010
Correct COAL for Lee TL452-230-TC?
I'm looking for the correct COAL for .45 ACP using the Lee TL452-230-TC tumble lube bullet.
I have examined this thread here:
And this spreadsheet here:
And based on these I figure a COAL of 1.210
However, even when I seat at 1.185, and I drop the bullet into the chamber of my P90 barrel, it sticks, and when I remove it, there is a tiny ring around the shoulder of the bullet nose, which tells me I am bottoming out on lead and not the case mouth.
In order to get it to just kiss off the case mouth, I have to seat to 1.170.
Should I let my barrel chamber be my guide for setting the bullet depth, such that when I drop it in it can spin freely on the case mouth?
I'm loading with 4.8 grains of Bullseye, FYI.
Nevermind, I found the answer back in one of my old posts here:
grubbylabs found this mold in the Lyman 4th edition with a COAL of 1.170, an that is just about exactly right from what I am measuring.
Last edited by maillemaker; February 13, 2013 at 11:59 PM.
|February 14, 2013, 01:03 AM||#2|
Join Date: December 26, 2004
Location: Louisville KY
You think that's bad, I had to load my 358-125-rf to 1.02 in my CZ before it would pass the plunk test.