The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Art of the Rifle: Semi-automatics

Reply
 
Thread Tools
Old February 28, 2013, 02:29 AM   #1
Departed402
Senior Member
 
Join Date: September 25, 2009
Location: Nebraska
Posts: 865
2nd bullet canting upward in Gen 2 PMAGs

My friend’s Magpul Gen 2 PMAGs are are having an issue, and as you can see in the photos, the second round in the magazine cants upward. The bullets can be put into this position simply by inserting the magazine, and he didn’t seem to be slamming the PMAGs in with any excessive force. I did not see these PMAGs in action on the range, but when the charging handle is racked all the way and released the result is a double feed. My primary concern is that this issue should not exist. My friend says he has been storing these PMAGs upside down with the dust covers on. I checked his Gen 3 PMAG and the bullets would not readily be put in this position; however, I pull second bullet into the position like in the photos of the Gen 2 PMAGs fairly easily. Have any of you guys seen this issue before? If so, have the PMAGs functioned normally in your experience? Are there ways to prevent it?



Departed402 is offline  
Old February 28, 2013, 02:43 AM   #2
Quadpod88
Member
 
Join Date: February 27, 2013
Posts: 93
I had gen2 p-mags when i was downrange. I actually never had a problem with them. They might be defective set. You could try pulling the springs and letting them rest. If that doesn't work try calling the company and complaining.
__________________
God made all men, but it was Sam Colt who made them equal.
Quadpod88 is offline  
Old February 28, 2013, 11:48 PM   #3
NESHOOTER
Senior Member
 
Join Date: October 16, 2009
Posts: 509
change the follower that one could be bugged...
NESHOOTER is offline  
Old March 1, 2013, 12:04 AM   #4
Fishbed77
Senior Member
 
Join Date: November 23, 2010
Posts: 2,684
I have a 20-round gen 2 Pmag that has the same problem. Magpul makes a bazillion mags and there is bound to be a lemon. I find that if I am careful loading it, it works fine for a range mag.
Fishbed77 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:11 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06692 seconds with 9 queries