The Firing Line Forums

Go Back   The Firing Line Forums > Hogan's Alley > Handguns: The Revolver Forum

Reply
 
Thread Tools
Old February 10, 2013, 11:08 PM   #1
BoomieMCT
Senior Member
 
Join Date: August 5, 2010
Posts: 212
Help on a S&W .22

A friend is looking to sell a S&W .22 revolver he inherited. It is a six shot .22, not sure if it is an old Model 17 or K-22. Serial number on the grip is 252xxx, but 11xxx inside the crane (or is that a model number?). It's blue, no lug, maybe a 6" barrel.

Anyone have info or know a good website to check?
BoomieMCT is offline  
Old February 11, 2013, 10:06 AM   #2
Winchester_73
Senior Member
 
Join Date: December 20, 2008
Location: Pittsburgh PA
Posts: 2,859
Well we could probably identify the gun and date it for you. The SN you gave cannot be right, as it is out of range for a pre war gun, and for post war, they had a K prefix for many years. Even after the K prefix, there was a K in the SN, perhaps until recently. If the SN (on butt of gun) is K 252XXX then it dates to approx 1953. I have my grandfather's K-22 which is K253XXX which dates to 1953, IIRC.

11XXX inside the crane is likely an assembly number, used for factory purposes, IE it has no meaning to us. The gun should be a 5 screw, if the number you gave has a K prefix. Look for a screw on the upper right hand corner of frame, right below the rear sight. That screw was the first to be removed for K and N frame revolvers.

Once again, assuming that the SN has a K prefix, it would be considered a K-22 masterpiece which is the predecessor to the later model 17. Some people call what you may have a pre 17. these were usually blue, and had a 6in barrel most often. There was a 4in variant made, which is the K-22 combat masterpiece.

As for a website, there is the S&W forum, but most often, everyone references the SCSW 3rd which many people here have anyways, including myself. Verify the SN (K prefix or not) and post a pic if you can.
__________________
Winchester 73, the TFL user that won the west
Winchester_73 is offline  
Old February 12, 2013, 10:34 AM   #3
BoomieMCT
Senior Member
 
Join Date: August 5, 2010
Posts: 212
Quite right, there is a K in the serial number. It was just far left justified.

It's in pretty good condition with a little wear on the blue and no box. Any idea what a good price for it would be?
BoomieMCT is offline  
Old February 13, 2013, 04:40 PM   #4
Sevens
Senior Member
 
Join Date: July 28, 2007
Location: Central Ohio
Posts: 9,163
A good price for you to snipe it? Or a fair price for him to get when he sells it?

A K-frame Smith & Wesson .22cal revolver that's in perfect working order and in great exterior shape without the original box that's as old as this one seems to be is routinely going to be priced between $600 and $700 at a gun show, and will sell somewhere a bit lower than that price in most cases.

Things to consider...
We still know almost squat about the condition of this particular revolver. It's horribly difficult even to do it with pictures... and we don't even have pictures. One guy's "GREAT SHAPE!" is another guy's "wow, every one of these 12 things is a chink in the armor."

That's just how it is. And again, if you are trying to get it from him for a fair price, that's different than hm attempting to get top-dollar for it.

There's definite value here. They made MANY of these, but they are absolutely in demand. Well kept, these guns will last lifetimes.
__________________
Attention Brass rats and other reloaders: I really need .327 Federal Magnum brass, no lot size too small. Tell me what caliber you need and I'll see what I have to swap. PM me and we'll discuss.
Sevens is offline  
Old February 13, 2013, 07:04 PM   #5
laytonj1
Senior Member
 
Join Date: June 1, 2005
Location: Alabama
Posts: 3,501
K252xxx dates it to 1955 which makes it a K-22.
S&W began assigning model numbers around 1957 at which time the K-22 became the model 17.

Jim
laytonj1 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:44 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06348 seconds with 7 queries