The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Gear and Accessories

Reply
 
Thread Tools
Old February 7, 2013, 06:48 PM   #1
1-DAB
Senior Member
 
Join Date: May 5, 2010
Location: Santa Fe, NM
Posts: 154
Portable target stand

made this this afternoon, base is 18x36, middle section is also 18x36, and top is 18x24, all 3/4" plywood, cut to 3" wide and joined with pocket screws. some smaller pieces cut to 4" long for the brackets on the base and between the top and middle sections. still need to add cardboard to top section. no tools needed to put together or take apart, should fit in most any trunk.

1-DAB is offline  
Old February 7, 2013, 09:47 PM   #2
redrick
Senior Member
 
Join Date: December 5, 2007
Location: Virginia
Posts: 834
I made one out of pvc. I got the idea off of youtube. It took me about 5 mins. to make.
redrick is offline  
Old February 8, 2013, 01:23 PM   #3
gundog5
Senior Member
 
Join Date: January 27, 2013
Posts: 116
Nice stand
gundog5 is offline  
Old February 8, 2013, 03:22 PM   #4
nazshooter
Senior Member
 
Join Date: November 7, 2008
Posts: 151
Thanks for posting that. I normally use campaign signs but I've run out and really need to make something up.

Sent from my ADR6425LVW using Tapatalk 2
nazshooter is offline  
Old February 8, 2013, 04:02 PM   #5
Babyfacenelson
Member
 
Join Date: February 4, 2013
Location: Georgia
Posts: 42
Well done!
I also use those campaign signs a lot, i keep shooting through the wires though, i may to need rethink where i tape up the target sheets
Babyfacenelson is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:13 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06768 seconds with 9 queries