The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old February 18, 2013, 09:55 PM   #1
Junior Member
Join Date: December 29, 2007
Posts: 12
Browning-380 auto, hard to pull Slide

The slide on this auto is very hard to pull back. I have stoned the hammer
face and this helped some, I have assembled the gun without the recoil
spring and found the slide works freely without the hammer spring installed.
Is there a replacement spring that would help with this situation ?
or, Any suggestion ?

Good shooting

varmintpopper is offline  
Old February 19, 2013, 09:07 AM   #2
Senior Member
Join Date: September 28, 2008
Posts: 7,167
Before going to all the trouble of changing the gun, and maybe risking a loss of reliability, make sure you are using the best of techniques for racking the slide.
Most folks I see at the range don't, and struggle with their smaller autos.
Do a web search and youtube search on the subject to find out how.
Like this:
Lock the doors, they're coming in the windows.
g.willikers is offline  
Old February 19, 2013, 09:40 AM   #3
Senior Member
Join Date: March 16, 2007
Location: Tucson, AZ
Posts: 3,348
There is probably noting the matter with your gun. I've shot my neighbors Browning and the slide is not easy to rack back. I have a Beretta that is essentially the same gun and it's a bit difficult too. It's just the design. Gwillikers advice is right on.
JWT is offline  
Old February 19, 2013, 12:33 PM   #4
Junior Member
Join Date: December 29, 2007
Posts: 12
Thanks for the replies. Never thought about looking for a Youtube vid on
this subject, but now I can teach the young lady who owns this gun the
method shown on Youtube. perhaps it will make it easier for Her.

Good Shooting

varmintpopper is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 04:29 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04949 seconds with 9 queries