The Firing Line Forums

Go Back   The Firing Line Forums > Hogan's Alley > Handguns: The Semi-automatic Forum

Reply
 
Thread Tools
Old January 30, 2013, 09:29 PM   #1
bedbugbilly
Senior Member
 
Join Date: November 19, 2009
Posts: 2,156
??? on grips for Sig Sauer 1911-22

I did a quick search but didn't find an answer . . if I over looked it I apologize.

I finally picked up a new Sig Sauer 1911-22 this past week - been wanting one for some time and ran across one that was on special. The typical Sig rosewood grips are attractive but I'd really like to change them out for a set of more "GI looking" double diamond checkered walnut grips.

So my question - I know that a few of the parts are interchangeable with the standard 1911 (not all). Are the grips? If I purchase a set of walnut grips for a standard 1911, will they work on the Sig 1911-22? The Sig has the ambidextrous safety on it but in looking at it, I don't think that the safety lever would interfere with the grip panel on either side if standard 1911 panels would work and I change them out. Is this correct or what do I need to be looking for?

Many thanks. I'm hoping that there are enough 1911 lovers on here who may have standard 1911s and a Sig or GSG 1911-22 that could easily straighten me out on the grips and if they are interchangeable.
__________________
If a pair of '51 Navies were good enough for Billy Hickok, then a single Navy on my right hip is good enough for me . . . besides . . . I'm probably only half as good as he was anyways. Hiram's Rangers Badge #63
bedbugbilly is offline  
Old January 31, 2013, 11:57 AM   #2
Marquezj16
Senior Member
 
Join Date: April 3, 2011
Posts: 2,088
If I remember correctly, mine would fit with some fitting. Can't remember if it was the screws or clearance.
Marquezj16 is offline  
Old January 31, 2013, 04:29 PM   #3
x-five
Member
 
Join Date: January 30, 2013
Location: Custer county, Montana
Posts: 55
Ivory, only ivory.
x-five is offline  
Old January 31, 2013, 09:16 PM   #4
qwiksdraw
Senior Member
 
Join Date: May 23, 2012
Posts: 361
Yes you can install standard 1911 grips on your Sig 1911 22LR, just make sure they are cut for the ambi safety.

I put some Rio Grande grips on mine, fit perfectly.
qwiksdraw is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:14 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06344 seconds with 9 queries