The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Dave McCracken Memorial Shotgun Forum

Reply
 
Thread Tools
Old January 22, 2013, 03:27 PM   #1
twilly
Junior Member
 
Join Date: October 30, 2012
Posts: 4
'Closet' gun question

I am considering re-tasking an old 'Ranger 5000' - 12 guage into sort of a 'Lupara' home defense gun. I don't know the vintage since there is no serial number. The receiver and forearm are both stamped C5389 - from this I assume it might have been early in a production run but not sure. I was thinking a good cleaning, oiling and chopping the barrels to around 19 inches. My only concern is would it handle modern loads. Any thought/comments would be appreciated.
twilly is offline  
Old January 22, 2013, 05:26 PM   #2
PetahW
Senior Member
 
Join Date: September 19, 2008
Posts: 4,679
It would need to be first checked by a competant double gunsmith (not some parts-changer), since your post mentioned barrelS (plural).

IIRC, the Ranger's SxS's were early 1900's Steven's - which would definitely need to be checked for being "on face" (or not), sound (or not) ribs, and any dents/bulges in the barrels, besides ID'ing the chamber specs.


.
PetahW is offline  
Old January 22, 2013, 06:46 PM   #3
Dfariswheel
Senior Member
 
Join Date: May 4, 2001
Posts: 6,830
Also note that a lot of these old guns have 2 1/2" chambers instead of the modern 2 3/4".
Shooting a longer modern round in an old short chambered gun is very unsafe.
Dfariswheel is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:56 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06022 seconds with 7 queries