The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old January 21, 2013, 07:50 PM   #1
Sgt Pepper
Senior Member
 
Join Date: August 19, 2001
Location: Texas
Posts: 687
Casing issue at primer

What issue is indicated by the condition of the primer area of these casings? Thanks.

Sgt Pepper is offline  
Old January 21, 2013, 08:00 PM   #2
wncchester
Senior Member
 
Join Date: December 1, 2002
Posts: 2,828
Nothing. Your firing pin hits are a bit erratic in depth and that suggests some of your cases may be a bit short but if they fire they're fine. ??
wncchester is offline  
Old January 21, 2013, 08:03 PM   #3
243winxb
Senior Member
 
Join Date: July 26, 2011
Posts: 838
High Pressure with Primer Wipe

"Primer wipe" is a teardrop-shaped firing pin impression, accompanied by a drag mark (scratch or gouge) following the "point" of the teardrop and leading away from the primer, sometimes into the brass. This is because the firing pin does not fully retract after the round has fired and the slide is traveling back during ejection, causing the case to drag across the firing pin as it is thrown clear. It is not in any way harmful, except sometimes to the case if the primer pocket edge is gouged. Kahr will tell you it is a normal condition for their pistols, even saying so in the owner's manual. [IMG][/IMG] click for larger photo.

Last edited by 243winxb; January 21, 2013 at 08:23 PM.
243winxb is offline  
Old January 21, 2013, 08:23 PM   #4
243winxb
Senior Member
 
Join Date: July 26, 2011
Posts: 838
45 acp Short Chamber

Or maybe a short chamber? [IMG][/IMG]The primers shows pressure signs cause by a short chamber in 45 acp, 1911 type firearm. As the action opens the high primer gets primer wipe. A gun smith corrected the chamber problem with a reamer. Not sure i buy this as the cartridge headspaces on the case mouth. Not sure how it could build pressure this way as the bullet is not trapped/ crimped into the chamber like a bottle neck round in a bold action rifle. The 45acp short chamber would hold the action open a tiny amount but still fire if the disconnector was not activated. A bulge might appear near the head if pressure was high. Very Strange.
243winxb is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:36 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2013 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07439 seconds with 9 queries