The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old January 20, 2013, 08:26 PM   #1
covcreo
Junior Member
 
Join Date: January 15, 2013
Posts: 4
Cleanest powderthat provides the best results.

Hey fellow Reloading enthusiast. I am new to the forum and am looking for a really clean burning powder for my DE44.

I have read that V V N110 burns the cleanest but I cannot find any 44 240 grain HP XTP load data for it. I have also seen in various forums that of 2400, 296, and H110 (296 and H110 being basically the same powder) 2400 burns the dirtiest. your opinion on this is appreciated.

I had a large supply of bulls-eye that I have been loading for my Red Hawk for some time but, need a clean load for my new 44 DE.

So what is the Best/Cleanest powder and what load data for these do you use?
covcreo is offline  
Old January 20, 2013, 10:51 PM   #2
spacecoast
Senior Member
 
Join Date: October 14, 2009
Location: Sunshine and Keystone States
Posts: 4,152
I'm not trying to be difficult, but why are you looking for the cleanest possible powder? To avoid cleaning? Unlikely with any powder...

I use H110 in my .44mag revolver, be very careful to stay at or above minimum loads (but less than max) since it's not very receptive to downloading, and use magnum primers.
spacecoast is offline  
Old January 20, 2013, 11:17 PM   #3
Sure Shot Mc Gee
Senior Member
 
Join Date: January 2, 2012
Posts: 2,127
Quote:
CAUTION: The following post includes loading data beyond currently published maximums for this cartridge. USE AT YOUR OWN RISK. Neither the writer, The Firing Line, nor the staff of TFL assume any liability for any damage or injury resulting from use of this information.
Blue Dot is pretty clean. IMR 4227 is also and is my preference over all for my Redhawk. As for what I have published here in regards to N110 usage:

1. Minimum:-- N110-19.8--1386 fps.--240 gr jacketed bullet.
2. Maximum:----------21.9--1531 fps.
__________________
Watch it!!! their both out to get us.
Sure Shot Mc Gee is offline  
Old January 21, 2013, 01:27 PM   #4
Martys
Member
 
Join Date: January 19, 2013
Posts: 24
I load for quite a few calibre's and W231, Tightgroup & Varget virtually handle all my requirements for both pistol's revolver, and rifles (223 & 308). Hope that helps.
Martys is offline  
Old January 21, 2013, 01:46 PM   #5
Sevens
Senior Member
 
Join Date: July 28, 2007
Location: Central Ohio
Posts: 9,120
Quote:
I'm not trying to be difficult, but why are you looking for the cleanest possible powder? To avoid cleaning? Unlikely with any powder...
The Desert Eagle is a gas-op semi-auto with a port and a piston and the fouling does kind of go everywhere. In loading for a Desert Eagle, it can be quite advantageous to at least try to keep it clean if you can simply by choosing a powder that has the reputation for leaving less residue.

In my experience in loading for a .44 Mag Desert Eagle, I've ran 240gr jacketed slugs (Nosler) with a heavy charge of Alliant 2400. I haven't yet experimented with other powders to get a better feel for things.

One thing that is typically true with most powders is that they tend to run cleaner that harder you run them. 2400's reputation is that when you run it lighter, you end up with more unburnt granules of powder.

I consider my loading for a .44 Mag Desert Eagle to be very much a work in progress.
__________________
Attention Brass rats and other reloaders: I really need .327 Federal Magnum brass, no lot size too small. Tell me what caliber you need and I'll see what I have to swap. PM me and we'll discuss.
Sevens is online now  
Old January 21, 2013, 11:34 PM   #6
bluetopper
Senior Member
 
Join Date: December 16, 2005
Location: Paris, TX
Posts: 1,104
Accurate 4100 or Ramshot Enforcer.....same powder.

Burns clean and performs wonderful without all the muzzle flash.
__________________
I use Liberal tears as gun lubricant.
bluetopper is offline  
Old January 22, 2013, 04:39 AM   #7
iraiam
Senior Member
 
Join Date: September 6, 2012
Location: Lakewood, CO
Posts: 875
H110 is my favorite powder for my .44 and .357, it burns plenty clean enough for me. I can't say it's the cleanest as there are many powders I have not tried.
__________________
NRA Lifetime Member Since 1999

"I ask, sir, what is the militia? It is the whole people except for a few public officials." George Mason
iraiam is offline  
Reply

Tags
296 , 44 mag , desert eagle , n110 , powder

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:47 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07397 seconds with 9 queries