The Firing Line Forums

Go Back   The Firing Line Forums > Hogan's Alley > Handguns: General Handgun Forum

Reply
 
Thread Tools
Old January 22, 2013, 08:09 AM   #1
Picher
Senior Member
 
Join Date: December 14, 2004
Location: Maine
Posts: 2,726
Repairing light scratches on SS guns

I recently bought a used Ruger Stainless MKII pistol, but it had some light scratches that made bright streaks on an otherwise nicely brushed finish. Note that these were not deep gouges, just some light scratches that may have been caused by dragging the gun across a hard-edged surface.

Thought about polishing the whole gun, like a stainless revolver I had, but thought better of it, wanting to keep it looking "factory" as much as possible.

So, how to duplicate the brushed effect without re-brushing the whole gun? Being a part-time gunsmith, I had some 120 grit carborundum powder and thought of how it's used for engine-turning, but didn't want to do that. Hmm, how about using a pencil eraser with grit to stroke parallel to the original brushed finish, so I tried it and it worked GREAT! I just dabbed the eraser into some grit, then stroked across the scratch a little wider than the scratch.

I should have taken before and after pictures, but take it from me that it worked amazingly well. The gun looks almost perfect. I can't see any finish variations when viewed closely.

Some folks may find similar results from fine steel brushing or emery paper, but this was quick and limited in area, basically to take the "shine" off the scratches. Hope this information is useful.

JP
__________________
People are like rifles. Some are tried and true, having great eyes, personality, and fun to be with. Others never seem to hit the mark with you. Still others go off half-cocked. Still, it's nice to know most of them.
Picher is offline  
Old January 22, 2013, 02:15 PM   #2
Alabama Shooter
Senior Member
 
Join Date: December 20, 2012
Location: Sweet Home
Posts: 886
That is good info, very helpful thanks.
__________________
Tomorrow is the most important thing in life. Comes into us at midnight very clean. It's perfect when it arrives and it puts itself in our hands. It hopes we've learned something from yesterday.
Alabama Shooter is offline  
Old January 22, 2013, 02:46 PM   #3
Dragline45
Senior Member
 
Join Date: November 30, 2010
Posts: 2,367
Simpler solution would be to use the dark red or light grey scotch-brite pads.
Dragline45 is offline  
Old January 22, 2013, 08:46 PM   #4
gpjoe
Member
 
Join Date: September 24, 2012
Posts: 51
Quote:
Simpler solution would be to use the dark red or light grey scotch-brite pads.
Yep.

I have used Scotch-Brite on some beat up brushed stainless steel watch bracelets with great success. With a steady hand you can replicate the brushed finish nicely.
gpjoe is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:37 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07546 seconds with 9 queries