The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old January 19, 2013, 11:57 AM   #1
Regwal
Junior Member
 
Join Date: January 17, 2013
Location: St. Marys, Georgia
Posts: 3
Undercoverette 32, 6 shot

Hi everyone, I'm new to the site and have a question hoping one of you can help me with. I was given a Charter Arms Undercoverett 32 and I would like to dismantle and clean. The cylinder is very hard to unlock for loading and I hope cleaning will correct this problem. Where can I locate instructions for field stripping?
Regwal is offline  
Old January 19, 2013, 04:47 PM   #2
Bill DeShivs
Senior Member
 
Join Date: April 7, 2006
Posts: 7,119
Pull the end of the ejector rod, instead of using the thumb release.
Once the cylinder is open, there is a small screw in the center of the breech face. This screw should be adjusted flush with the breech.
__________________
Bill DeShivs
www.billdeshivs.com
Bill DeShivs is offline  
Old January 20, 2013, 11:04 AM   #3
Regwal
Junior Member
 
Join Date: January 17, 2013
Location: St. Marys, Georgia
Posts: 3
Thanks Bill. As near as I can tell the screw is flush already. I cleaned good this morning and it is working better but not smooth. Perhaps it is the nature of this gun?
Regwal is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:00 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06179 seconds with 9 queries