The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old January 23, 2013, 10:08 PM   #1
cogito
Member
 
Join Date: October 16, 2012
Location: Mid-Western State
Posts: 37
slide not locking with new mag -- dremel it?

Howdie,

I just bought some Pachmayr mags for my Sig P226. They feed without issue, but the slide doesn't lock after the first round.

Looking at the mag, the metal gap where the slide lock would hit is a bit narrow as is the corresponding place on the follower.

So, I presume I could just open it up a bit with a dremel. Any advice?
cogito is offline  
Old January 24, 2013, 04:45 PM   #2
blfuller
Senior Member
 
Join Date: January 8, 2013
Location: Washington State
Posts: 234
If this just started after you installed the Pachmayer grips the channel in the grips that the slide release moves up and down may be binding and preventing it from moving freely. I would not do any dremmeling.

Field strip the pistol and lift up and down on the slide release. If it does not move freely, remove the grip and see if it moves freely. Put the factory grips back on and check movement. If it moves freely with the old grips and does not with the rubber Pachmayer, get a razor blade and clean the slot out, remove any flash or open it up a little until the slide release moves freely like it did with the factory grips.
blfuller is offline  
Old February 2, 2013, 07:37 PM   #3
CraigJS
Senior Member
 
Join Date: July 31, 2005
Posts: 372
He said nothing about changing grips!
CraigJS is offline  
Old February 2, 2013, 07:55 PM   #4
blfuller
Senior Member
 
Join Date: January 8, 2013
Location: Washington State
Posts: 234
My bad, I saw Pachmayr and thought grips, didn't know they even made mags for the SIG 226. I know they used to for the 1911 but that was it. If thats's the case I'd return them or exchange. I'd stick with factory or MecGar which is suppose to OEM the mags for SIG.

If you can't return them then I'd do the dremmeling or contact Pachmayr and see what they say.
blfuller is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:46 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06814 seconds with 9 queries