The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old January 20, 2013, 11:32 AM   #1
Nathan
Senior Member
 
Join Date: July 1, 2001
Posts: 1,976
Smart way to change powder or shot in Lee Load All

I'm getting started reloading shotshells with my Lee Load All. Looks like a pretty good setup, but how do I change powder or shot bushings without making a mess? Or, just dump powder back in it's container for storage?
Nathan is offline  
Old January 20, 2013, 12:42 PM   #2
Ifishsum
Senior Member
 
Join Date: September 15, 2005
Location: Oregon
Posts: 709
If I'm not loading again within I week I would store powder back in the original container rather than in the load-all. It is a bit of a pain to be sure; I actually mounted mine to a piece of plywood and use clamps to hold it to the bench. Makes it easier to dump unused powder back - otherwise you have to scoop and/or cycle the charging lever until the hoppers are empty. Changing a bushing on a full hopper is a real mess - so before starting a new load, I load the hopper only 1/4-1/3 full with powder and verify the throws on my scale before adding shot and filling up the powder. Then I record the recipe including the bushing number so it's easier the next time.
Ifishsum is offline  
Old January 20, 2013, 01:02 PM   #3
klyph3
Member
 
Join Date: July 11, 2012
Posts: 59
I also use one bolted to a board, board clamped to bench. You can make a half lid by heating a piece of plastic sheet (like a milk jug) and forming it over one side to keep the shot/powder separate when you dump it.
klyph3 is offline  
Old January 20, 2013, 03:01 PM   #4
5R milspec
Senior Member
 
Join Date: December 11, 2009
Location: South Carolina
Posts: 360
put a lage clean cup under it and pump away
__________________
life is great but its better when you can own as many guns you wish to own.for me I haven't bought enough yet.
5R milspec is offline  
Old January 20, 2013, 04:01 PM   #5
Pat T
Member
 
Join Date: January 29, 2009
Location: NW PA
Posts: 83
When I used one I used to pry the handle slightly out off the studs that hold the loader to the base and slide it off. Then dump powder & shot into respective containers. Don't know if they are still made that way.
Pat T is offline  
Old January 20, 2013, 05:35 PM   #6
GP100man
Senior Member
 
Join Date: August 1, 2007
Location: Tabor City , NC.
Posts: 1,923
dismount & turn it all upside down .
__________________
GP100man
GP100man is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:41 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06953 seconds with 9 queries