The Firing Line Forums

Go Back   The Firing Line Forums > Hogan's Alley > Handguns: The Semi-automatic Forum

Reply
 
Thread Tools
Old December 31, 2012, 10:34 PM   #1
baddarryl
Senior Member
 
Join Date: March 29, 2011
Location: Cape Fear!
Posts: 994
Problems with WWB in a Buckmark?

Hi all. I picked up a very clean Buckmark URX used. I have had it out for 2 very short sessions. The first I determined to be magazine related (are they rebuildable?). Then I shot 3 mags full the second time and had at least one stovepipe and one failure that was ammo related. I was using the cheap WWB bulk stuff. Do these pistols ever get finicky of ammo? I am going to give it a good cleaning and try again soon and maybe take some different ammo with me. Thanks.
baddarryl is offline  
Old December 31, 2012, 11:30 PM   #2
rrockefe
Member
 
Join Date: August 15, 2007
Location: Surprise, AZ
Posts: 39
I wouldn't use that WWB bulk crap in any .22 now. I was using it in a Beretta NEOS and it was scattering like a shotgun. After finally checking the barrel real close, I found terrible leading had occurred. After I cleaned it out and tried 4 other brands that all shot well I knew it wasn't the gun. Then I tried the WWB in an old target rifle (Rem. 513T) and it shoots pretty well with no leading. So now I use Federal bulk in the NEOS and will get rid of the WWB through the 513T. Perhaps the barrel surface in that rifle made many years ago is considerably smoother than the NEOS and doesn't scape off the lead shavings. I don't know, but I've bought my last box of it. It also occasionally failed to completely eject on the last round. In the rifle I had two case separations of the rim. Just all around bad stuff!
rrockefe is offline  
Old January 1, 2013, 12:52 AM   #3
chris in va
Senior Member
 
Join Date: December 26, 2004
Location: Louisville KY
Posts: 12,528
Switch to CCI and carry on.
chris in va is offline  
Old January 1, 2013, 01:12 AM   #4
BarryLee
Senior Member
 
Join Date: July 29, 2010
Location: The ATL (OTP)
Posts: 2,737
Quote:
Switch to CCI and carry on.
Yes, I had a few issues with a couple of different brands of ammo, but after switching to CCI exclusively I have experienced zero issues. The only problem is with the recent run on ammo we may be stuck with what we can find.
__________________
A major source of objection to a free economy is precisely that it ... gives people what they want instead of what a particular group thinks they ought to want. Underlying most arguments against the free market is a lack of belief in freedom itself.
- Milton Friedman
BarryLee is offline  
Old January 1, 2013, 07:19 AM   #5
geetarman
Senior Member
 
Join Date: November 18, 2009
Location: Arizona
Posts: 2,746
I use CCI in mine and don't have any problems. I do buy other than CCI for use in a lever gun, bolt gun or revolver.
__________________
Geetarman

Carpe Cerveza
geetarman is online now  
Old January 1, 2013, 11:45 AM   #6
Hal
Senior Member
 
Join Date: October 9, 1998
Location: Ohio USA
Posts: 7,435
Buy a box of Stingers.

Fire a few. It doesn't have to be in the Buckmark since all you're after is the spent cases.

When cleaning the Buckmark, take one of the spent Stinger cases and push it into the chamber.
It will cut the "crud ring" in the chamber that's built up by the lube on the standard length, 40 grain, .22lr ammo.

It's the same idea behind using a spent .357mag case in a .357 mag that's been fired w/.38spl to remove the "crud ring".

I keep a few loose spent Stinger cases in my range bag. I shove one in the chamber to ream it out after every couple/few hundred shots with every .22 I shoot.

When you say WWB, would that be the Winchester Wildcats?
IMHO - Wildcats are lower on the food chain than Remington Thunderbolts.
Both are filthy, but, at least the Thunderbolts shoot straight compared to the Wildcats.
Hal is offline  
Old January 1, 2013, 12:00 PM   #7
baddarryl
Senior Member
 
Join Date: March 29, 2011
Location: Cape Fear!
Posts: 994
Hal- my box says White Box and nothing about Wildcats. Thanks for the tip on the Stingers. I will try something else for the Buckmark. I have a bolt action Marlin that I can feed these WWB to.
baddarryl is offline  
Old January 1, 2013, 01:17 PM   #8
GregInAtl
Senior Member
 
Join Date: December 29, 2010
Location: Gwinnett County Georgia
Posts: 747
I have had problems with CCI as well in my new Buckmark, However, the feed/stovepiping problems become fewer and farther between as the gun becomes more broke in.
__________________
"The worst place to have your happiness is in sombody else's head" -Lester Sumrall
GregInAtl is offline  
Old January 1, 2013, 02:27 PM   #9
Dashunde
Senior Member
 
Join Date: December 22, 2004
Posts: 1,697
Mine runs good on the Federal bulk packs.
Dashunde is offline  
Old January 1, 2013, 09:40 PM   #10
jfrey
Senior Member
 
Join Date: May 16, 2008
Location: Coastal South Texas
Posts: 551
I run nothing but CCI Blazer or Federal Champion through mine and it works great. Tried other stuff and it didn't like it so I stayed with what works.
jfrey is offline  
Old January 1, 2013, 10:09 PM   #11
treg
Senior Member
 
Join Date: November 26, 2006
Posts: 1,023
Mine runs good on the Winchester 555 bulk packs. In the past (up to 25 years ago) I have found that some of the lower end (Blazers, Wildcats, etc) are weaker and do not operate the slide correctly such as you describe. I would do as HAL suggests with the Stinger case and try some CCI or Winchester SuperX ammo. Surely you can find some bulk pack ammo that will serve for range and blasting if desired once you prove your gun.

Thanks for the tip HAL.
__________________
"Courage is being scared to death and saddling up anyway." - John Wayne

.44 Special: For those who get it, no explanation is necessary. For those who don't, no explanation is possible.
treg is offline  
Old January 2, 2013, 05:47 AM   #12
NWCP
Senior Member
 
Join Date: December 24, 2006
Posts: 1,795
The best ammo I've found for the two Buckmarks I own is the CCI Standard Velocity. No FTF, FTE, or any other issues. It's just as accurate as their Green Box premium ammo but not near as expensive. I also use it in my .22LR long guns, both bolt and semi auto. Good stuff. CCI ammo in general is good for what ails you. I avoid the majority of bulk ammo such as the Winchester bulk ammo. It's a shame though. You'd think with the name and history behind the company that Winchester would do a better job with their rimfire ammo. Remington isn't much better.
NWCP is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:07 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.09275 seconds with 9 queries