The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools
Old December 31, 2012, 03:56 AM   #1
Senior Member
Join Date: October 7, 2009
Posts: 995
30.06 to 7.65X53mm

I'm not new to reloading....but I am new to cartridge conversions.

After watching some YT clips I understand the 'art' of working & lubing the brass in the die(s), but I'd like to know your experience on cartridge conversions. Thanks.
warningshot is offline  
Old December 31, 2012, 09:34 AM   #2
Senior Member
Join Date: October 18, 2006
Posts: 5,953
That is a pretty straight forward conversion. Just anneal, run it through the die, and trim to length (I like the Lee case length gauge trimmers for this, although with that much brass to remove a different method would be smart).

Other common (and some uncommon) brass that will work to form 7.65 Mauser; 270 Win, 7x57, 8x57, 25-06, 257 Roberts.

"Gorsh" said Goofy as secondary explosions racked the beaten zone, "Did I do that?"
Jimro is offline  

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 04:32 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.05579 seconds with 9 queries