The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old December 24, 2012, 09:16 PM   #1
Curtis67
Junior Member
 
Join Date: December 22, 2012
Posts: 3
model 70 Winchester 7mm short mag failure to eject

Two different times now ive had failure to eject final
Round from mag.its just stuck n the barrel. Round fired fine.
Any ideas fellas?
Curtis67 is offline  
Old December 25, 2012, 12:57 AM   #2
4V50 Gary
Staff
 
Join Date: November 2, 1998
Location: Colorado
Posts: 17,005
Extracted round is OK suggests to me there's no excessive expansion of the cartridge and that chamber pressure is OK.

Clean the extractor and beneath the extractor.
If that doesn't work, you might have to change the extractor spring (insufficient pressure to cause extractor to hold onto the case while it is being withdrawn).
__________________
Vigilantibus et non dormientibus jura subveniunt. Molon Labe!
4V50 Gary is offline  
Old December 25, 2012, 07:23 PM   #3
wyop
Senior Member
 
Join Date: July 15, 2012
Location: Wonderful, Windy Wyoming
Posts: 133
And maybe check that the extractor is sharp.
wyop is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:42 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05594 seconds with 7 queries