|December 24, 2012, 12:00 PM||#1|
Join Date: December 23, 2012
Looking for a pair of rubber grips for a iver johnson top break 38 s&w. Just wondering if they make them or did make them or even wood ones woud work.
|December 25, 2012, 12:05 PM||#3|
Join Date: September 19, 2008
Vintage grips has them, but there are three sizes for .38 cal IJ revolvers, and it depends whether you revolver is hammerless or an exposed hammer type - you need to measure your gun and compare those to the measurements for each of the three grips.
The screws are not included, but Vintage Grips has them if you order them also.
Measuring backside of right panel (vertical not diagonal) 2 17/32" long
1 1/8" wide across center of screw hole @ butt
Dimensions / Sizes for the Iver Johnson .38 Break Top Revolver Grips.
Measuring right panel (vertical not diagonal)
2 7/16” @ longest point
1 1/8” wide across center of screw hole
1 5/32” wide across center of pin hole
Iver Johnson .38 Brk Top Rev. w/Hammer
Measuring back side of right panel (vertical not diagonal)
2 ½” long
1 1/32” between “ears” – tip to tip
1 1/8” wide across center of pin hole
|Thread Tools||Search this Thread|