The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old December 14, 2012, 04:35 PM   #1
JimDandy
Senior Member
 
Join Date: August 8, 2012
Posts: 2,402
Serial Number on my Hornady Press?

I've got the LNL Ammo Plant, getting ready to send in the receipts and whatnot from a pair of dyes, and the ammo plant for the free bullets, as well as the warranty registration card. I found a number on the bottom of the ram, but it's not really the same format as the others mentioned.
JimDandy is offline  
Old December 14, 2012, 06:29 PM   #2
newrugersafan
Member
 
Join Date: February 1, 2010
Location: Oregon
Posts: 43
Should be on the inside of the press, look at the rear support. Mine has a sticker that is about 1"x11/2" just below the area that the dies are located.
newrugersafan is offline  
Old December 14, 2012, 06:52 PM   #3
JimDandy
Senior Member
 
Join Date: August 8, 2012
Posts: 2,402
Yup, there it is... I hate it when I miss the hind-sighted-obvious. I found a number stamped into the casting way down on the bottom of the ram, covered and partially filled by the red paint. I spent a good 10 minutes filling that with glue (for contrast, it's all I had on hand, still need to get a laquer stick) and trying to figure out what that number was.
JimDandy is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:54 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06011 seconds with 9 queries