The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Art of the Rifle: Semi-automatics

Reply
 
Thread Tools
Old December 7, 2012, 01:03 AM   #1
Sweet Shooter
Senior Member
 
Join Date: June 17, 2011
Posts: 506
RRA A2 rear sight chopped handle.

I just bought this sight... for a handle type sight it's a bit spendy but I have to say it is primo engineering. Clicks are sure, and it looks super cool. Much nicer than any other non-flip rear I have tried. I can't wait to sight this in. It's my primary iron for my M400.
-SS-
Sweet Shooter is offline  
Old December 7, 2012, 09:16 AM   #2
madcratebuilder
Senior Member
 
Join Date: November 2, 2007
Location: Northern Orygun
Posts: 4,871
Like this LMT A2 rear sight?



I didn't care for the larger thumb nut so I cut it down and have a small lock-nut installed.
madcratebuilder is offline  
Old December 7, 2012, 05:07 PM   #3
Sweet Shooter
Senior Member
 
Join Date: June 17, 2011
Posts: 506
Similar... the RRA doesn't have the single big wheel nut... instead has two hex wrench bolts and a heavy side rail clamp. I did look at those LMT but wanted one without the big wheel nut... also the RRA looked and felt much tighter...

-SS-
Attached Images
File Type: gif sarsa.gif (28.6 KB, 10 views)
Sweet Shooter is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:13 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06934 seconds with 10 queries