The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old December 13, 2012, 01:34 PM   #1
iraiam
Senior Member
 
Join Date: September 6, 2012
Location: Lakewood, CO
Posts: 873
Ruger Redhawk Scope Scallops (cutting)

I'm want to cut scope scallops into the barrel rib on my Ruger Redhawk, and make it into a "Hunter" Model.

Any smithies around that have done this?

I could not find any prints or drawings around, so I went ahead and oredered the Ruger rings and will take detailed measurements off of them. I have looked at a couple Hunter models at the LGS, the machining required is not complex.
__________________
NRA Lifetime Member Since 1999

"I ask, sir, what is the militia? It is the whole people except for a few public officials." George Mason
iraiam is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:15 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05776 seconds with 9 queries