The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Harley Nolden Memorial Institute for Firearms Research

Reply
 
Thread Tools
Old September 6, 2012, 08:55 PM   #1
troutmaster
Junior Member
 
Join Date: September 6, 2012
Posts: 2
Browning BLR

I am new here, so hello, and thanks in advance for any help....

I recently acquired a Browning BLR and I am trying to figure out the basic history of it, specifically the manufacture date. My search of serial numbers doesn't match any format I have seen.

It is an older BLR, straight stock, in .308. It has no manual safety or hammer safety (hammer is solid). It is stamped "made in Japan" but has a black trigger, not a gold one. The magazine is not flush, but rather hangs down a half inch or so. SN is 04407 K47 It shows Patent number 3377731

Personally, my theory is it was built shortly after the manufacturing was moved from Belgium to Japan.

I am not much into lever guns, This gun was a impulse buy from an old timer selling off a few guns he had tucked away because his kids didn't have any interest in them. It now has my curiosity peek.
troutmaster is offline  
Old September 7, 2012, 08:54 AM   #2
PetahW
Senior Member
 
Join Date: September 19, 2008
Posts: 4,679
1974 - Nipponese number stamper cross-eyed, often reversed numerals in the early 70's.

"K" = (Model) BLR

"47" = 1974 (should have been stamped "74""

So, SN 04407K47 should have been SN 04407K74, but wasn't.

Shoulda, coulda, woulda...........................

.
PetahW is offline  
Old September 7, 2012, 11:06 PM   #3
troutmaster
Junior Member
 
Join Date: September 6, 2012
Posts: 2
Thanks for the explanation......The way I was reading it I knew the "47" should be the year code but I knew it was late 70's build. Didn't occur to me it might be transposed. I assumed machine stamping.
troutmaster is offline  
Old November 28, 2012, 09:11 AM   #4
summerman
Member
 
Join Date: November 19, 2008
Posts: 47
question for one who owns a BLR

do the screw holes on the receiver where it is tapped for a scope go all the way through into the chamber? That is, is you look into the top of the chamber can you see where it was tapped for a scope or rings? There aren't any around here for me to even look at. Thanks.
summerman is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:03 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.08522 seconds with 9 queries