The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old November 28, 2012, 05:34 PM   #1
dlbarr
Senior Member
 
Join Date: October 8, 2011
Posts: 160
Picking the correct sight combination

I posted this elsewhere on the forum but thought maybe it would be relative to this particular section...

I have an H&R Buffalo Classic in 45/70 - just rec'd it back from the factory fitting it. I have pretty much decided, unless someone can convince me differently, that I'm going to buy the Williams FP receiver sight to attach to the rear of the barrel. What I am having a challenge figuring out is what should the height be on the front sight - I want a globe sight, like the Lyman 17 series.

The center of the aperture (at its lowest adjustment) is .325" above the plane of the barrel in the rear. The difference in diameter between rear & front of the barrel = .310". So, dividing that in half = .155" which means that the center of the rear sight aperture is .470" (.325+.155) above the plane of the barrel where the front sight will rest.

So...ideally, should the front sight height be as close as possible to the exact measurement of the rear sight (.470)? And since it will likely be impossible to match this exactly, is it better to have a shorter or higher front sight given that the rear sight is measured at its lowest setting? Also, the fact that this is a 45/70 with its unique trajectory characteristics, how does that figure into these calculations?

I should probably add that my main interest is hunting and informal shooting. I can be convinced to start in some friendly competition at my local range, but shooting beyond 200 yds is probably not going to be much of an interest to me.

Thanks a bunch for any help.
dlbarr is offline  
Old November 28, 2012, 08:59 PM   #2
PetahW
Senior Member
 
Join Date: September 19, 2008
Posts: 4,561
I dunno - When I bought my BC (early on), it came sans sights.

So, I just installed the proper WGRS atop the bbl in the factory holes/prep, and a Lyman #17 up front, then shot/zeroed it w/o problem.

I don't worry much about every problem, until one arises.


.
PetahW is offline  
Old November 28, 2012, 10:49 PM   #3
dlbarr
Senior Member
 
Join Date: October 8, 2011
Posts: 160
yeah, I'm not worrying about a problem either. my barrel came like yours: w/o sights. but i dont want a f/r sight combo that doesnt work because their not matched in terms of height
dlbarr is offline  
Old November 29, 2012, 01:36 PM   #4
guncrank
Senior Member
 
Join Date: July 15, 2006
Location: Fern Creek ,KY and Metro Louisville at large
Posts: 313
Pick the closet one , better lower than higher.
__________________
CW Shooters Supply Inc
1-866-217-5990
Machine Shop and Finishing Services to the trade and public
guncrank is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:24 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2013 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07126 seconds with 9 queries