Lowers without a rollmark

djcantr · November 20, 2012, 02:01 AM

I want to find a lower without a rollmark or with a very small one. I have a friend in the service. He doesn't have an AR yet and I'd like to find a stripped lower without a rollmark so I could have it laser engraved. Any ideas where to find one?

madcratebuilder · November 21, 2012, 09:12 AM

Start with a 80%. Law requires a certain amount of info on the receiver. Nodak Spud may have a lower with small roll marking.

Ridge_Runner_5 · November 21, 2012, 09:52 AM

I had a Spikes Tactical blemish receiver a couple years ago that had no rollmark on it.

madcratebuilder · November 22, 2012, 10:16 AM

That's unusual, what's on the other side? What side did they place the serial number?

Ridge_Runner_5 · November 22, 2012, 12:58 PM

The serial and model number are still there on the bottom of the side. But they didn't stamp their spider on it.

saands · November 24, 2012, 06:40 PM

http://www.tacticalmachining.com makes their lowers on CNC mills ... probably the same mills that they use for their 80% lowers. If you aren't in a hurry, I would bet that they would make you one without the roll mark and just put on the necessary info.

Saands

November 20, 2012, 02:01 AM	#1
djcantr Senior Member Join Date: January 28, 2012 Posts: 215	Lowers without a rollmark I want to find a lower without a rollmark or with a very small one. I have a friend in the service. He doesn't have an AR yet and I'd like to find a stripped lower without a rollmark so I could have it laser engraved. Any ideas where to find one?

November 21, 2012, 09:12 AM	#2
madcratebuilder Senior Member Join Date: November 2, 2007 Location: Northern Orygun Posts: 4,868	Start with a 80%. Law requires a certain amount of info on the receiver. Nodak Spud may have a lower with small roll marking.

November 21, 2012, 09:52 AM	#3
Ridge_Runner_5 Senior Member Join Date: February 8, 2008 Location: Castle Rock, CO Posts: 1,746	I had a Spikes Tactical blemish receiver a couple years ago that had no rollmark on it.

November 22, 2012, 10:16 AM	#4
madcratebuilder Senior Member Join Date: November 2, 2007 Location: Northern Orygun Posts: 4,868	That's unusual, what's on the other side? What side did they place the serial number?

November 22, 2012, 12:58 PM	#5
Ridge_Runner_5 Senior Member Join Date: February 8, 2008 Location: Castle Rock, CO Posts: 1,746	The serial and model number are still there on the bottom of the side. But they didn't stamp their spider on it.

November 24, 2012, 06:40 PM	#6
saands Senior Member Join Date: November 14, 1999 Posts: 1,548	http://www.tacticalmachining.com makes their lowers on CNC mills ... probably the same mills that they use for their 80% lowers. If you aren't in a hurry, I would bet that they would make you one without the roll mark and just put on the necessary info. Saands