|October 31, 2012, 05:11 PM||#1|
Join Date: October 31, 2012
colt officers model 38special parts needed
I thought it would be an easy thing to do an internet search for parts for this gun, but that is not the case, I guess it's just too old to find parts recently made, a family member gave it to me to repair/restore I need a mainspring and a few other parts as this one is heavely rusted. anybody have a source?
I believe I read that colt trooper parts can be used as they use the same frame.
|October 31, 2012, 06:11 PM||#2|
Join Date: November 2, 2005
Have you tried Numrich GPC. they have Trooper mainsprings listed, both original and reproduction. Whoops, their site may be down for a while because of Sandy.
Last edited by RJay; October 31, 2012 at 06:29 PM.
|November 1, 2012, 06:28 PM||#3|
Join Date: May 4, 2001
The Officer's Model is a Colt "E&I" frame. These all used the same action parts, with the "E" frame having the firing pin mounted on the hammer, and the "I" frame having the pin in the frame.
"E&I" frame Colt's are:
The Colt 3-5-7.
Again, almost all action parts are interchangeable.
Here's sources for parts.
NOTE: Most action parts are hand fitted and require gunsmith knowledge to install.
Used parts had already been altered and may not be usable in your specific gun.
New parts are getting scarce.
DO NOT expect to buy most parts and have them just drop in, especially used parts.
A smart move is to buy the Jerry Kuhnhausen shop manual.
This was written as a training aid for new gunsmiths. It covers ALL parts installation and gunsmithing on the Colt "E&I" frame guns. All repairs shown are done the factory way, which is to restore the gun to factory specs.
This is the best money you can spend if you own a Colt.
Here's the manual and sources of parts:
Gotta call, but the best parts house. They also make some new Colt parts.
Click on COLT and WAIT, it's slow loading.
|Thread Tools||Search this Thread|