The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old October 17, 2012, 12:39 PM   #1
rebs
Senior Member
 
Join Date: January 10, 2012
Posts: 2,295
RCBS VLD chamfering tool ?

I went to try this tool to remove military crimp but the point hits the bottom of the flash hole before the cutter hits the crimp. Is there a way to grind it down without loosing the hardness of the cutter ?
rebs is offline  
Old October 17, 2012, 02:41 PM   #2
William T. Watts
Senior Member
 
Join Date: January 20, 2010
Location: Central Arkansas
Posts: 832
If you do what you suggest you would ruin the tool, a L.E. Wilson chamfering tool will do exactly what you want. I've used my chamfering tool to cut the crimp on some HXP cases, I didn't particularly like the cases because of weight variance and recycled them.. William

Last edited by William T. Watts; October 18, 2012 at 10:52 PM.
William T. Watts is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:45 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06429 seconds with 7 queries