The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old October 12, 2012, 07:08 AM   #1
rajbcpa
Senior Member
 
Join Date: August 27, 2012
Posts: 306
Using a Hornady and RCBS powder measure on a Dillon 550B?

After a few months of total furstration with a Hornady L-N-L progressive press that I am unable to get running reliably, I am giving up on it and I will buy a new Dillon 550B.

Can I use the Hornady powder measure on a Dillon 550B? Apparently, Dillons come with a powder measure but many users have separate powder measures for each caliber they load.

I also have a RCBS powder measure. Can I use this on a Dillon 550B too?

The factory powder measure that comes with the Dillon 550B has a built-in case bell expander and the Hornady and RCBS powder measures do not. The Dillon is a 4 stage press, so if I use the Hornady and RCBS powder measures without any case bell expanders, I would need to have to do the bullet seating and case crimping in one station which should not present an issue; right?

Thx..
rajbcpa is offline  
Old October 12, 2012, 08:18 AM   #2
rox
Member
 
Join Date: October 4, 2012
Posts: 53
Quote:
I also have a RCBS powder measure. Can I use this on a Dillon 550B too?
I sometimes use an RCBS measure on my 1050, so you should be able to do the same on a 550B (perhaps someone can confirm that there is sufficient space in the relevant station). You would need the RCBS Case Activated Linkage kit, which fits the Uniflow-based measures. Apparently expander options are available that work with the case activated linkage kit, like this one.

..
rox is offline  
Old October 12, 2012, 10:43 AM   #3
wogpotter
Senior Member
 
Join Date: September 27, 2004
Posts: 2,723
Yes you can, but with varying degrees of difficulty on connecting to the auto powder dump system.

There is an adaptor that lets you use any standard powder measure with Dillon's existing die. You leave the die in place as you would with Dilon's measure, attach the adaptor to the upper part of the die & then screw the powder meter into the upper section one of several "mouth adaptors" to fit the meter to the adaptor.
__________________
Allan Quatermain: “Automatic rifles. Who in God's name has automatic rifles”?

Elderly Hunter: “That's dashed unsporting. Probably Belgium.”
wogpotter is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:07 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2013 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06178 seconds with 9 queries