The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old October 10, 2012, 08:11 AM   #1
UncleGrumpy
Member
 
Join Date: March 10, 2012
Posts: 32
.303 British Trouble seating Hornady bullets

Hi,

I am trying to reload with the Hornady 150grn sp bullet which i have not used before.

Using Winchester brass, I have re-sized each case with the RCBS dies, chamfered inside and out but each time I try to seat the bullet it catches on the neck and then deforms the neck.

Would someone please tell me what I am doing wrong.

Cheers
UncleGrumpy is offline  
Old October 10, 2012, 08:34 AM   #2
chiefr
Senior Member
 
Join Date: January 27, 2010
Location: AR
Posts: 1,199
The only thing I can think of would be to make sure your expander rod (The rod in the sizing/depriming die) is exactly 311 or 312 in diameter, It should at least be the same diameter as your bullet. Providing your brass is new. If not new:

I would also mike your bullets to make sure they are not oversized.

Next, make sure your brass is not to thick at the neck. May have to either outside neck turn or ream inside with 311 reamer.


If none of the above, then you have a sizing die problem.

One last thing, If you are shooting a milsurp 303, the chambers are know to be inconsistent. I would neck size only.
chiefr is offline  
Old October 10, 2012, 08:41 AM   #3
wogpotter
Senior Member
 
Join Date: September 27, 2004
Posts: 3,014
I use exactly that combination with no problems, so something is wrong.
Measure the bullet diameter & the inside case neck diameter after resizing.
__________________
Allan Quatermain: “Automatic rifles. Who in God's name has automatic rifles”?

Elderly Hunter: “That's dashed unsporting. Probably Belgium.”
wogpotter is offline  
Old October 10, 2012, 07:02 PM   #4
UncleGrumpy
Member
 
Join Date: March 10, 2012
Posts: 32
hi,

i worked it out. I forgot to wind the die back out a few turns. The die was crimping the neck.

Cheers
UncleGrumpy is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:22 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06211 seconds with 9 queries