The Firing Line Forums

Go Back   The Firing Line Forums > Hogan's Alley > Handguns: The Revolver Forum

Reply
 
Thread Tools
Old October 14, 2012, 03:33 PM   #1
akinswi
Member
 
Join Date: October 14, 2012
Location: Murfreesboro, TN
Posts: 51
44 special loads

I have ruger super black hawk in 44 mag and looking for any load data on a 240gr FN bullet in Green Dot for 44spl. I have #7 powder but it leaves a bunch of unburnt powder when i load it to specs. But I was using magnum primers because I didn't have any large pistol primers at the time and that could have been the issue, the #7 worked really great in 44mag burned reall clean and not much muzzel flash. But I don't want to shoot a couple hundred 44 mag rounds my hand cant take it. I like to try some green dot in 44spl because I have boat loads of it.

thanks
akinswi is offline  
Old October 14, 2012, 03:45 PM   #2
NWPilgrim
Senior Member
 
Join Date: September 29, 2008
Location: Oregon
Posts: 2,152
Unique is my favorite powder for .38 and .44 Special. W231 works well, too.
NWPilgrim is offline  
Old October 14, 2012, 03:58 PM   #3
PawPaw
Senior Member
 
Join Date: December 24, 2010
Location: Central Louisiana
Posts: 3,113
If you know how to navigate the Alliant website you can find some neat recipes that you might not otherwise find.

The Alliant website says that you can use Green Dot in the .44 Rem Magnum, and recommends 7.0 grains with a 240 LSWC and the CCI 300 primer for 901 fps. You might be able to transform that information over to the .44 Special. It doesn't seem like a particularly powerful load. Your mileage might vary.

I use Unique for the .44 Special. 7.5 grains under my 240 lead cast bullet gives me 970 fps with good accuracy. That load does 95% of anything I want a .44 handgun to do.
__________________
Dennis Dezendorf

http://pawpawshouse.blogspot.com
PawPaw is offline  
Old October 14, 2012, 06:00 PM   #4
IDAHOMIKE
Senior Member
 
Join Date: November 25, 2007
Location: Gooding, ID
Posts: 348
I myself prefer Unique and 2400, but I do know some fellers that have real good luck with Greendot.
__________________
Need some top notch gunleather? Please check out my facebook page at: http://www.facebook.com/#!/pages/A-T...05958232763057 and my website at http://atouchofyellowleatherwerkes.weebly.com/
10% discount for TFL members. Thanks for looking!
IDAHOMIKE is offline  
Old October 14, 2012, 06:30 PM   #5
Bob Wright
Senior Member
 
Join Date: July 10, 2012
Location: Memphis, Tennessee
Posts: 1,893
Many years ago I was given an almost full 8# keg of Green Dot. I got it from a friend who had bought it for shotgun use, so was not afraid to use it. Besides, the green dots pretty well identified it.

I never used it in the .44 Special, but did in the .41 Magnum. Pretty close to Unique, as I recall. Sorry I couldn't be of any help.

Bob Wright
Bob Wright is offline  
Old October 14, 2012, 06:52 PM   #6
Hook686
Senior Member
 
Join Date: May 22, 2005
Location: USA The Great State of California
Posts: 1,943
A second data point: I have a copy of Alliant web data for .44 magnum using green dot from a few years ago. It lists maximum of 8.7 grains, with Federal 150 primer for 1190 fps at a chamber pressure of 35,000 psi with 240 grain JSP. Paw Paw did not mention chamber pressure with his data. I suggest you contact Alliant and ask them for starting point with Green Dot for the bullet you plan to use. I have always found them to be very helpful.
__________________
Hook686

When the number of people in institutions reaches 51%, we change sides.

Last edited by Hook686; October 15, 2012 at 02:07 AM.
Hook686 is offline  
Old October 14, 2012, 07:11 PM   #7
drail
Junior member
 
Join Date: February 2, 2008
Posts: 3,150
I used a lot of Green Dot many years ago for .41 and .44 medium power loads and it worked very well. There should be plenty of data published. The Speer manual always had data for all of the Dot powders. Unique is now my choice for .44 Spl. Good velocities and low pressures. Cases last forever.
drail is offline  
Old October 14, 2012, 07:15 PM   #8
Bob Wright
Senior Member
 
Join Date: July 10, 2012
Location: Memphis, Tennessee
Posts: 1,893
I burned a lot of Unique as well as a lot of other Hercules powders. Then one day, on a lark, I tried Hodgdon powders, especially HS-6 for light to medium loads and been using that ever since. Actually I tried Winchester 540 first, then that was dropped and HS-6 was its twin, I stuck with HS-6.

My favorite powders now are Winchester 231, HS-6, and #2400.

Bob Wright
Bob Wright is offline  
Old October 14, 2012, 07:51 PM   #9
rclark
Senior Member
 
Join Date: February 12, 2009
Location: Butte, MT
Posts: 1,660
Quote:
looking for any load data on a 240gr FN bullet in Green Dot for 44spl
Fired in Ruger .44Spec Flattops 5 1/2" barrels :

6g Green Dot under 240 SWC 950fps. Accurate
7g Green Dot under 240 SWC 1027fps . Accurate.

Hope that helps!
__________________
A clinger. When guns are outlawed, only outlaws will have guns. Single Action .45 Colt (Sometimes improperly referred to by its alias as the .45 'Long' Colt or .45LC). Don't leave home without it. Ok.... the .44Spec is growing on me ... but the .45 Colt is still king.

Last edited by rclark; October 14, 2012 at 11:08 PM.
rclark is offline  
Old October 14, 2012, 08:01 PM   #10
GeauxTide
Senior Member
 
Join Date: April 20, 2009
Location: Helena, AL
Posts: 3,080
I am also a Unique fan, although I like 8.0gr for 240 Missouri SWC.
GeauxTide is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:46 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.09419 seconds with 9 queries