The Firing Line Forums

Go Back   The Firing Line Forums > Hogan's Alley > Handguns: The Semi-automatic Forum

Thread Tools Search this Thread
Old September 23, 2012, 03:11 PM   #1
Join Date: February 14, 2012
Posts: 17

Hi all!

I've been having FTE issues with my Ruger P95. cleaned chamber well, cleaned extractor hook with a pick, brush and Hoppes no.9. After one of the failures, I tilted up the pistol and tapped the side. casing wouldn't fall out, I had to pull it out. I'm wondering if the chamber diameter wasn't machined large enough? Any thought? For the record, this was a replacement barrel installed at the factory for a defect.
Ruger2014 is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 09:35 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.08872 seconds with 7 queries