The Firing Line Forums

Go Back   The Firing Line Forums > Hogan's Alley > Handguns: The Revolver Forum

Reply
 
Thread Tools
Old October 13, 2012, 04:48 PM   #1
obamasucks760
Junior member
 
Join Date: October 13, 2012
Posts: 2
Ruger Blackhawk help

I just purchased what I believe is a newer model ruger blackhawk, and the ejector rod wont go into any of the cylinders. It gets caught on the edge of every one. I tried tightening the ejector rod screw but that didnt help. Can i get some pointers?
obamasucks760 is offline  
Old October 13, 2012, 05:05 PM   #2
KROIL
Senior Member
 
Join Date: August 25, 2006
Posts: 270
The loading gate must be open and the cylinder rotated to line up for you to push the ejector rod in to punch tha case out.
KROIL is offline  
Old October 13, 2012, 06:29 PM   #3
skidder
Senior Member
 
Join Date: August 17, 2008
Location: Montana
Posts: 630
They are off centered from the click. You have to manually line them up to eject them properly.
__________________
Gun permit?? A bread crumb tossed to a sleeping society awoken by the sound of complacency. "They are for your own good", and "you will understand when you see all the lives they save". Yes master, what else will you toss me from your bag of infringements?? Do you want me to roll over and play dead? I do that very well. --skidder
skidder is offline  
Old October 13, 2012, 08:09 PM   #4
Bob Wright
Senior Member
 
Join Date: July 10, 2012
Location: Memphis, Tennessee
Posts: 1,846
You probably have a smaller caliber Blackhawk, .30 Carbine or .357 Magnum. Your ejector rod should have a flat on the inner surface, rather than being a round rod. This to provide more clearance to enter the chamber.

Bob Wright
Bob Wright is online now  
Old October 13, 2012, 08:27 PM   #5
drail
Junior member
 
Join Date: February 2, 2008
Posts: 3,150
Yup, on the .30 Carb. models there ain't much clearance for the ejector rod. After a while you'll become "proficient" at indexing the cyl. so the rod will go into the chamber.
drail is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:53 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07950 seconds with 9 queries