The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old September 22, 2012, 09:36 PM   #1
Infidel08
Junior Member
 
Join Date: August 11, 2012
Posts: 6
ruger sbh re assembly

Hey guys I'm looking for some help. I have a NM sbh in 44 mag. While cleaning it I removed the grip frame and cant get it to line back up with the screw holes in the rest of the gun. And a spring loaded plunger is givin me probblems. Any advice is appriecated.
Infidel08 is offline  
Old September 22, 2012, 11:33 PM   #2
drail
Junior member
 
Join Date: February 2, 2008
Posts: 3,150
Get the Ruger manual.
drail is offline  
Old September 23, 2012, 12:17 PM   #3
PetahW
Senior Member
 
Join Date: September 19, 2008
Posts: 4,679
You DID cock it and slip a small pin through the hole in the tail of the mainspring strut, to take the spring pressure off, BEFORE you removed the gripframe screws, right ? .


.
PetahW is offline  
Old September 23, 2012, 10:34 PM   #4
James K
Staff
 
Join Date: March 17, 1999
Posts: 20,019
The spring loaded plunger sounds like the hand spring. You should just be able to compress it by pushing on the grip frame.

Jim
__________________
Jim K
James K is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:53 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06332 seconds with 9 queries