BHP extractor adjustment

80viking · September 2, 2012, 04:45 PM

I just replaced the extractor and spring on my BHP, now it extracts every time, but it still leaves the last empty shell in the port. It extracts fine but without a round in the mag to support it, the empty case falls out from the extractor before it gets to the ejector. There does not seem to be any extractor tension on the cartridge rim.

So, my question is, do I remove some material from the bump on the inside of the extractor until I get extractor tension on a case similar to a 1911?

Thanks, John

**James K** · September 2, 2012, 08:25 PM

That is what I would do.

Jim

80viking · September 3, 2012, 12:47 PM

Thanks Jim, I wasn't sure if I would create another problem by doing that.

John

September 2, 2012, 04:45 PM	#1
80viking Senior Member Join Date: December 8, 2009 Location: The Peoples Republic of Massachusetts Posts: 274	BHP extractor adjustment I just replaced the extractor and spring on my BHP, now it extracts every time, but it still leaves the last empty shell in the port. It extracts fine but without a round in the mag to support it, the empty case falls out from the extractor before it gets to the ejector. There does not seem to be any extractor tension on the cartridge rim. So, my question is, do I remove some material from the bump on the inside of the extractor until I get extractor tension on a case similar to a 1911? Thanks, John

September 2, 2012, 08:25 PM	#2
James K Staff Join Date: March 17, 1999 Posts: 16,439	That is what I would do. Jim __________________ Jim K

September 3, 2012, 12:47 PM	#3
80viking Senior Member Join Date: December 8, 2009 Location: The Peoples Republic of Massachusetts Posts: 274	Thanks Jim, I wasn't sure if I would create another problem by doing that. John