The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old October 2, 2012, 08:03 PM   #1
Josh Smith
Senior Member
 
Join Date: November 5, 2000
Location: Wabash IN
Posts: 515
Annealed Brass - TempilStik

Hi All,

With all the conflicting information out there about annealing, I decided to experiment a bit.

I'd heard I needed a pan of water; that no, a air cooling was fine; to make the neck glow and to keep the neck from glowing and the flame from changing color, as either indicated a cooking-off of zinc from the copper (zinc melts at about 790°).



Structural changes begin in brass at 650°, so I used a TempilStik crayon that turns to liquid at that temperature.

I marked the case in three places: 1/4" below the shoulder, halfway down the case body, and at the head.

The TempilStik melted below the shoulder at 8 seconds. An additional 2 seconds did not melt the crayon halfway down the body, so it looks like for this particular setup, which is a 9/16" deep wall socket stuck in an electric screwdriver, 10 seconds per case, air cooled, gives adequate annealing without burning out the zinc.

Josh
__________________
-
Sights for the Mosin-Nagant
-
Josh Smith is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:53 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05310 seconds with 9 queries