The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Gear and Accessories

Reply
 
Thread Tools
Old September 24, 2012, 09:46 AM   #26
Yung.gunr
Senior Member
 
Join Date: November 11, 2010
Location: Phoenix area
Posts: 1,340
I think that if you can look down the barrel like on a bolt gun or take off the upper on an AR and look down the barrel a laser bore sighter is not needed. I recently sighted in my AK and that was a pain because the sight was WAY off and I couldn't see down the barrel. If I have to do it again I will get the posterboard like someone else mentioned.

All the reviews of boresighters I have seen are 50/50. I would rather spend that boresighter money on ammo. Even if I am using more ammo like I did with my AK it was still enjoyable for me pulling that trigger.
Yung.gunr is offline  
Old September 25, 2012, 10:12 PM   #27
wpsdlrg
Senior Member
 
Join Date: August 18, 2009
Posts: 460
" i saw a tool where you place it in the front on your gun barrel and the top part is a graph what is that tool called?"


The tool is called a collimator.

The interesting thing about laser boresighters or collimators is that they themselves need to be zeroed, or gotten very close, in order to work properly. That is why they have windage and elevation adjustments. Theoretically, if the collimator is properly zeroed (especially for the desired zero distance for the rifle)....then the laser can be used to dial in a scope, without firing a shot.

Unfortunately, however, such devices are seldom spot-on - and it is a bit of a hassle to get them set up. I know this by way of experience. So, at this point, I prefer to bore sight the good old fashioned way - by sighting through the barrel. Less hassle, actually - and since the purpose of boresighting is to get the rifle CLOSE (but not zeroed), so as to not waste ammo at the range....this method works well enough. Further, it costs nothing and can be quite precise. I've gotten my rifles adjusted, via the old-fashioned method, close enough that only around 1 inch or so of actual adjustment of the POI has been required, in order to zero the rifle. That is every bit as precise as any of the laser collimators on the market will allow - without a lot of tedious set up, anyway.
wpsdlrg is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:59 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05628 seconds with 7 queries