The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting > Bullet Casting

Reply
 
Thread Tools
Old August 27, 2012, 01:42 PM   #1
armoredman
Senior Member
 
Join Date: May 22, 2007
Location: Arizona
Posts: 3,752
Need some quick info, 40SW barrel diameter

I slugged a 40 SW pistol bore, came up with .402. Factory bullets are .400/.399, on the few I've looked at. Factory bullets gave unimpressive accuracy. Cast bullets sized industry standard at.401 gave mediocre accuracy and bad leading.Oversize cast bullets sized at .404 gave excellent accuracy and minimal to no leading.
Question, to 40SW owners who have slugged their bores, it this the same diameter you have come up with, groove to groove? Groove depth is approx .003, so a .400 bullet has .001 to engage the rifling, not counting obturation, which I would have to assume is minimal with a jacketed projectile.
The factory representative refused to give me the information over the phone, wouldn't even say whether or not such a diameter is within factory specs, so I ask you, the experienced casters and re loaders, is this a normal diameter? Not mentioning the manufacturer until I get some good info on whether I am wrong or right, and I've been wrong more than once before.
__________________
http://czfirearms.us/ same original CZForum, new location.
armoredman is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:02 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06020 seconds with 9 queries