The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old August 7, 2012, 08:28 AM   #1
Join Date: July 12, 2009
Posts: 76
LCR Internal Lock

Has anyone disassembled a Ruger LCR? I hope so, as I have two questions.

1. The internal hammer block. No, I am not one of our members that thinks an internal safety is a government conspiracy. I just will never use it. It appears the safety / hammer block works by preventing the hammer strut from moving. It appears to be held in place by four pins and if you "pushed out" the four pins the "block" will come out of the grip peg. Am I correct?

2. I like to remove the cylinder for cleaning. The LCR manual does not describe a procedure for removing the cylinder. It appears from the drawing, in the manual, the cylinder is retained by the "crane pivot screw". If the "crane pivot screw" is removed, can the cylinder be easily removed?



Last edited by Jerry11826; August 7, 2012 at 08:30 AM. Reason: Goof up
Jerry11826 is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 06:14 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.09843 seconds with 9 queries